MIL-N-46025 Nickel Bar, Flat Wire Ribbon And Strip For Electronic UseThis specification covers one grade of nickel for electronic use in the forms of bar, flat wire ribbon and strip see 6.1.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

MIL-N-46025B(MR)

      Table VIII.  Width tolerances for flat wire (ribbon)        

Width,

Tolerance, inch

   inch                                       (plus and minus)        

Over 0.099 to 0.187, incl.                       .016        

3.4.3  Length.  If cut straight lengths are specified, the lengths shall be within the limits as specified in table V.

3.4.4  Permanent set.  The flat wire (ribbon) shall be sufficiently rigid so that when 1-1/4 turns are cut free from a spool, the diameter of the resulting loop shall not exceed the flange diameter of the spool on which the wire is furnished.

3.5  Strip.

3.5.1  Thickness.  The thickness of strip shall not vary by more than the amounts shown in table IX.

           Table IX.  Thickness tolerances for strip(1)

Tolerance (all widths),

Thickness,

inch

   inch                                        (plus and minus)        

Under 0.006,

0.006 to 0.015, incl.

Over 0.015 to 0.050, incl.

Over 0.050 to 0.093, incl.

10(2)

0.001

.0015

.0025

Over 0.093 to 0.125, incl.                        .004        

(1)Measured 3/8 inch or more from edge except for strip under 1 inch in width which is measured at any place.

(2)Expressed as percent of nominal thickness.

3.5.2  Width.  The width of strip shall not vary by more than the amounts shown in table X.

6

For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business