MIL-N-46025B(MR)
Table X. Width tolerances for strip1
Thickness,
Width,
Tolerance, inch
inch Inches (plus and minus)
0.009 and under
Over 0.009 to 0.024, incl.
Over 0.024 to 0.075, incl.
Over 0.075 to 0.100, incl.
All widths
All widths
14 and under
14 and under
0.005
.007
.007
.009
Over 0.100 to 0.125, incl. 14 and under .012
1For strip with slit edges only.
3.5.3 Length. Strip may be ordered to cut lengths in which case a variation of 0.125 inch over the specified length shall be permitted.
3.5.4 Straightness. The edgewise curvature (depth of arc) of strip shall not exceed 0.05 inch multiplied by the length in feet. Straightness for coiled strip shall be subject to agreement between the manufacturer and contracting officer.
3.6 Workmanship. Material shall be commercially free from dirt, oxide, scale, streaks, stains, grease, oil, lubricants, scratches, pit marks, burns, chattermarks, dents, blisters, laps, grooves, slivers, seams, cracks, inclusions and other injurious imperfections.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the supplier is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract or order, the supplier may use his own or any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
4.2 Lot. Unless otherwise specified in the contract or order, a lot shall consist of material of the same temper, finish, melt, or thickness made by the same manufacturing process, submitted for inspection at one time.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business